Conductive Foam Selection: The Gapped Seams Where One Part Handles Shielding, Grounding and Cushioning
Conductive foam suits gapped seams that need grounding and cushioning. Check ≥30 dB shielding (10–1000 MHz) and surface …
Thermal Gap Pad Cushioning: Choosing Thickness and Hardness to Protect Chips from Vibration
Use a thermal gap pad as a cushioning layer: check thickness, 5–40 Shore B hardness, compression and thermal resistance, …
Copper Foil Self-Adhesive Tape Holds Die-Cut Dimensions Under Web Tension
Copper foil tape with a copper substrate and listed dimensional stability in die-cutting. See how 0.009-0.07 mm …
Platinum Cured Transparent Silicone Tubing for Fluid Transfer: No Cure By-products, No Bloom
Platinum cured transparent silicone tubing: no peroxide by-products, no plasticizers, no bloom. -50 to 200°C, Shore …
UL 94 V-0 Thermal Silicone Encapsulant: Potting That Handles Heat and Flame Rating Together
H-GF-GY thermal silicone encapsulant lists UL 94 V-0 and 1.0-3.0 W/m·K. See how V-0 is judged, why thermal inertia …
Custom Co-extruded Conductive Silicone Gasket Profiles: Sizing Compression to Your Groove
Fit a co-extruded nickel-graphite conductive silicone gasket to your existing groove: check compression ratio and gland …
Phase Change Thermal Pad Contact: Solid at Assembly, Wets the Heat Sink Interface at 45 to 55°C
LXPCM phase change pads place solid, soften at 45-55°C, wet the heat sink joint and expel air. Why dry contact stalls …
Polyimide Gold Finger Tape Rated 8 kV: Reading Insulation Specs on a 0.065 mm Film
Polyimide gold finger tape rated ≥8 kV withstand voltage and ≥10^13 Ω surface resistivity at 0.065 mm. See how to read …
Thermal Conductive Silicone Cloth for -30°C to 200°C: One Sheet from Cold Start to Full Load
Thermal conductive silicone cloth rated -30°C to 200°C, 0.8 to 3.0 W/m·K, over 4 kV withstand voltage, fiberglass …
TO-220 Silicone Cap for -40 to +180°C: Wall Thickness, Hardness and Expansion Fit
Heat Conductive Silicone Cap rated -40 to +180°C: thickness by package, Shore A 70±5 hardness, D5470 conditions and an …
FFKM O-Rings for Semiconductor Vacuum Chambers: 320°C Service and a Leak Estimate Before Sampling
M-FFKM-02 FFKM O-ring: 320°C rating, 20% compression set at 300°C. Use a vacuum leak approximation to check temperature, …
Hydrolysis-Resistant Custom Shaped Silicone Tubing for Steam and Hot-Water Seals
Lixing custom shaped silicone tubing stays non-tacky and holds its profile in hot, wet seals. -45°C to 200°C, 30 to 80 …